Fengxzhang
Community Member
Hi all, it's been a while since I last posted. I recently added a PM1 module with ORP and a second temp prob. That's when the issues started, not sure if it's related. In short, here are the problems I'm currently experiencing.
1. My MP40s will turn off all of a sudden. I would then unplug and replug the power cable to the MP40 to "reset" it before it's working again.
2. Some of the Radions would not come on. I would also turn off (main power) and turn it back on to have it work again.
3. Unable to add Radion to my WXM. I had a fan go out on a Radion. At first, I thought it was software issue. I updated the firmware software on the Radion. Did a factory reset. Then I replaced the fan. The light works now, but I cannot connect it to the WXM. I would try to "add a radion" on the apex module. All it does is blink and nothing else happens.
4. Unable to use the "module config" function on the WXM.
I attempted to update the software (firmware?) on the WXM, but the display would just blink and nothing would happen. I am running the current firmware on the Apex and everything else (pH, Temp, ORP, other controls, PM1) is working just fine.
Please help! Thank you in advance!
1. My MP40s will turn off all of a sudden. I would then unplug and replug the power cable to the MP40 to "reset" it before it's working again.
2. Some of the Radions would not come on. I would also turn off (main power) and turn it back on to have it work again.
3. Unable to add Radion to my WXM. I had a fan go out on a Radion. At first, I thought it was software issue. I updated the firmware software on the Radion. Did a factory reset. Then I replaced the fan. The light works now, but I cannot connect it to the WXM. I would try to "add a radion" on the apex module. All it does is blink and nothing else happens.
4. Unable to use the "module config" function on the WXM.
I attempted to update the software (firmware?) on the WXM, but the display would just blink and nothing would happen. I am running the current firmware on the Apex and everything else (pH, Temp, ORP, other controls, PM1) is working just fine.
Please help! Thank you in advance!
