OP
OP
Country0922
Community Member
Bump
DIY rapid led layout
- Thread starter Country0922
- Start date
- Tagged users None
Wildman
Active Member
The UV, red, and green together is probably your best bet as they are all the same mA. It is kinda hard without knowing exactly what LEDs and what drivers you got. Typically the cree are 1500mA Whites, 1000 or 1500mA depending on which led you chose, red and UV 700mA, and green is 1000mA.
CarolinaReefs makes a good point. If you got epoxy from Rapid to glue on your lenses that is probably the thermal epoxy you need to glue down the two colored LEDs or you can drill new holes. Make sure you measure and don't drill into the fins on the back of the heat sink.
CarolinaReefs makes a good point. If you got epoxy from Rapid to glue on your lenses that is probably the thermal epoxy you need to glue down the two colored LEDs or you can drill new holes. Make sure you measure and don't drill into the fins on the back of the heat sink.
Bartmmackey
Active Member
Lighting classes in college tell me different. Just saying the forum is great, but the bible it ain't. The spectrum is the spectrum..gods speed my fine fishy friend.
OP
OP
Country0922
Community Member
Lol I'm not entirely sure either wildman
OP
OP
Country0922
Community Member
Of anyone's willing to draw up a diagram for me if they think there's another way of doing this it would be greatly appreciated
Lazys Coral House
Well-Known Member
Of anyone's willing to draw up a diagram for me if they think there's another way of doing this it would be greatly appreciated
Last edited:
OP
OP
Country0922
Community Member
We're you quoting me or something or just trolling?
