Chrisv.
2500 Club Member
After this week’s release of the A3, I made the decision to buy a sweet new A2 apex Base unit. Right choice for me in my circumstances.
I’m having trouble with setup: I started reprogramming outlets instead of sticking with presets. Ironically I set a light outlet in position 1, which is the preset position, and although it looks like it’s correctly programmed, the outlet failed to become active after I sent the new commands to the EB8 (carried over from my apex classic).
I followed the step by step setup and it looks right, but the outlet isn’t doing anything. I did the same thing with outlet #2, which I wanted to use as a heater. the reprogrammed outlet isn’t doing anything.
luckily outlet 4 is still preset as a heater, so I am running my heater through that for now. I have my light on outlet 6 which is preset to be a return pump and will stay on until I manual unplug the light later tonight.
any idea what I’m doing wrong? I did not erase any programming from my old eb8….not sure if I needed to.
I’m having trouble with setup: I started reprogramming outlets instead of sticking with presets. Ironically I set a light outlet in position 1, which is the preset position, and although it looks like it’s correctly programmed, the outlet failed to become active after I sent the new commands to the EB8 (carried over from my apex classic).
I followed the step by step setup and it looks right, but the outlet isn’t doing anything. I did the same thing with outlet #2, which I wanted to use as a heater. the reprogrammed outlet isn’t doing anything.
luckily outlet 4 is still preset as a heater, so I am running my heater through that for now. I have my light on outlet 6 which is preset to be a return pump and will stay on until I manual unplug the light later tonight.
any idea what I’m doing wrong? I did not erase any programming from my old eb8….not sure if I needed to.
