So I have a 240g tank, 8x2x2, I have 2xMP60s on each side running Reefcrest 100% antisync. The flow in the middle seems pretty lack luster. Any suggestions? Picture of tank added for reference.
MP60QD Suggestions - Flow Help
- Thread starter PaulieReef
- Start date
- Tagged users None
SPR1968
No, it wasn’t expensive dear....
Reef Squad
Reef Squad Leader
Excellence Award
Reef Tank 365
UK Reef Club Member
Hospitality Award
My system is a bit bigger but I have an MP40 in the middle for that exact reason
My MP60’s are just run on reef crest independently
My MP60’s are just run on reef crest independently
OP
OP
What size system and what percentage are you running everything at? I like the idea of separate reef crest for more random flow. Also where is your placement? Should I play them higher?
SPR1968
No, it wasn’t expensive dear....
Reef Squad
Reef Squad Leader
Excellence Award
Reef Tank 365
UK Reef Club Member
Hospitality Award
There’s a picture of the new tank empty and full on first page of my build thread
Link below and at side
The MP’s are on around 95% but will go to 100% for the main part of the day
OP
OP
Thanks!
ca1ore
10K Club member
Excellence Award
Reef Tank 365
CTARS Member
Article Contributor
R2R TV Featured
If you have enough clearance, putting the MP40 on the back wall helps - I do that on my 8x3x2 tank. I ales end up doubling my MP60s on each end, though my tank is a foot deeper. You could also try running the MP60s on pulse mode for part of the day.
OP
OP
Was thinking that. Old tank scares me with small waves.
I think the mp40 option is going to be best. I have an old gyre I might run too. Think that might also give the desired effect.
Until I can afford another mp40
