- Joined
- Jan 3, 2020
- Messages
- 52
- Reaction score
- 101
My torch needs some love and help!!
My tank info
Nano 15 gallon
Sal. 1.25
Cal. 480-500
Alk. 8.4
Rite. .0
Rate. .20
Ph 7.8-8.4
A little back story on my tank a few weeks ago my tank parameters started dropping mainly Alk 7.3 ph 6.8 and cal. 400 The tanks temp was high Around 80 from the 1st wave of heat in the house So I hooked up a small fan to the tank and picked up some Kent ph buffer and cal. After a few days I stop dosing the tank bc the parameters seemed to leveled off after dosing. And never dropped below my desired parameters. Testing all my parameters for another week also did a small water change and my torch started looking bad. Started seeing the skeletons on the sides then yesterday morning. A jelly slime took over the torch. Instantly I took the torch out the tank, Blasted the torch and dipped it seachem Iodine Dip. A small W.C. Then I placed the torch in a small diy Pico tank setup in a window for light w/ heater and bio media from the tank.
Im not sure if I can place the torch back in my tank or cut off the infected parts. Help any advice out there?

My tank info
Nano 15 gallon
Sal. 1.25
Cal. 480-500
Alk. 8.4
Rite. .0
Rate. .20
Ph 7.8-8.4
A little back story on my tank a few weeks ago my tank parameters started dropping mainly Alk 7.3 ph 6.8 and cal. 400 The tanks temp was high Around 80 from the 1st wave of heat in the house So I hooked up a small fan to the tank and picked up some Kent ph buffer and cal. After a few days I stop dosing the tank bc the parameters seemed to leveled off after dosing. And never dropped below my desired parameters. Testing all my parameters for another week also did a small water change and my torch started looking bad. Started seeing the skeletons on the sides then yesterday morning. A jelly slime took over the torch. Instantly I took the torch out the tank, Blasted the torch and dipped it seachem Iodine Dip. A small W.C. Then I placed the torch in a small diy Pico tank setup in a window for light w/ heater and bio media from the tank.
Im not sure if I can place the torch back in my tank or cut off the infected parts. Help any advice out there?


