2 clocks on fusion

[slipknotgrrl83]

After daylight savings yesterday I have 2 clocks on fusion. The time on apex display is reading right so why do I have one right on fusion and one the hour behind? Clock on device is right, auto set and dst enabled.. it' driving me nuts! Any suggestions?

 

[Hammer100]

i remember sometimes it took a while for the savings time update in fusion but not sure why

 

[slipknotgrrl83]

i remember sometimes it took a while for the savings time update in fusion but not sure why

Maybe... I mean it's correct on the display itself and my phone/computer so who knows

 

[Flameback Pair]

Which Apex do you have?

 

[slipknotgrrl83]

Which Apex do you have?

Apex jr

 

[rkpetersen]

Is your time zone correct?

 

[Birddog]

It'll go away, just give a couple of days. I've had my Apex for 4 years and it's the same thing every start and end of daylight savings time for me. I've never figured out how to make it go away on my own, but it always happens.

 

[_DZ_r€€f]

Just restart the apex and all wil be back to normal

 

[_DZ_r€€f]

It always happen when ther is time change

 

[slipknotgrrl83]

It'll go away, just give a couple of days. I've had my Apex for 4 years and it's the same thing every start and end of daylight savings time for me. I've never figured out how to make it go away on my own, but it always happens.

Good to know! Ty

 

[slipknotgrrl83]

Just restart the apex and all wil be back to normal

Ty will try that!

 

[slipknotgrrl83]

Is your time zone correct?

Yep

 

[jonmos75]

If you do not want to reboot the Apex unplug the Ethernet cable for 2-5 minutes and plug it back in. Then wait a few more minutes and you should see one clock tile in Apex Fusion like you did before.

 

[slipknotgrrl83]

If you do not want to reboot the Apex unplug the Ethernet cable for 2-5 minutes and plug it back in. Then wait a few more minutes and you should see one clock tile in Apex Fusion like you did before.

Ty! Will try when I get home!

 

[slipknotgrrl83]

If you do not want to reboot the Apex unplug the Ethernet cable for 2-5 minutes and plug it back in. Then wait a few more minutes and you should see one clock tile in Apex Fusion like you did before.

It worked, ty

 

[JoeIII]

This happens when the time on your controller (or more accurately, what Apex thinks the time is) doe snot match the time on your device. I see it whenever I travel and my time zone is different from home, one is local time, one is APEX time.

As was noted, it will also happen after DST changes until fusion gets an updated TZ from your APEX, because it still thinks the controller is using the old TZ and your browser is reporting the new one