2 questions Skimmer and calcium reactor

[zach_discus]

Hello two questions:

First one is easy. On my older CR200 with the blaster pump. The o ring in the ph probe mount riped and I need to replace. Where can I purchase one?

Second question, I have a Diable 300ext that was factory modified to use a various pump. It’s set up to drain into my frag tank due to space limitation near the main sump. I’m getting a lot of bubbles and splashing. Any suggestions on how to help with this?

Thanks Zach

 

[ndrwater]

Question one. Contact CoralVue. They are the distributors of RO products.

Question two. Extend the outlet below the water line in the frag tank

 

[zach_discus]

Question one. Contact CoralVue. They are the distributors of RO products.

Question two. Extend the outlet below the water line in the frag tank

Thanks for the reply:

Haven’t heard back from them on question one, so figured I would ask here.

Outlet goes 4” into the water of the frag tank already?

 

[Jeremy@CoralVue]

Please contact support at coralvue.com/support regarding sourcing the probe holder oring seal. Bubble in the output could be a number of things. If you are pumping a lot of water through it this will be rather normal. You can help by venting right before entering the water. I usually cut the pipe at an angle right at the water level so that air and water can go their own ways.

 

[zach_discus]

Please contact support at coralvue.com/support regarding sourcing the probe holder oring seal. Bubble in the output could be a number of things. If you are pumping a lot of water through it this will be rather normal. You can help by venting right before entering the water. I usually cut the pipe at an angle right at the water level so that air and water can go their own ways.

Thanks, I turned the output to about. 45deg angle going into the water. That helped greatly. Getting it broke in, starting to get a nice stanky foam!!