3D modeller needed

[fisherdonk]

Hello 3D printing aquarists!

I have found this 3D model for a cover of the sump part of a Fluval 13.5G tank. I was hoping that a kind soul more skilled than I in 3D printing could make the following modifications for me:

- Move the light mount hole to 3cm from the left edge.
- Make the cover flat
- Remove the second cable hole
- Widen the light mount hole to accommodate an ai prime gooseneck mount and thin cable (4 cm)

I think this would be a great contribution to the community given the popularity of this tank.

Thank you!

 

[vetteguy53081]

Under forums we have a 3D thread. Some talented people on there

 

[fisherdonk]

Ah i was under the impression I posted this in the DIY>3D sub forum

 

[neonreef3d]

Hello 3D printing aquarists!

I have found this 3D model for a cover of the sump part of a Fluval 13.5G tank. I was hoping that a kind soul more skilled than I in 3D printing could make the following modifications for me:

- Move the light mount hole to 3cm from the left edge.
- Make the cover flat
- Remove the second cable hole
- Widen the light mount hole to accommodate an ai prime gooseneck mount and thin cable (4 cm)

I think this would be a great contribution to the community given the popularity of this tank.

Thank you!

 

[Freenow54]

Way Cool want to watch this for sure