3D Printed Bracket for Booster Pump Power Supply

[fish101]

Has anyone designed a power brick holder for the aquatic RODI Booster Pump?

If not, who's willing to design one and sell it to me? Below is a link to the pump I'm talking about.

1/4" 8800 Booster Pump Kit

Boost Your RO/DI System's Performance Solves Low Pressure Problems: Ideal for RO/DI systems needing a pressure increase. Complete Solution: Includes all necessary components for a quick setup. Enhanced Efficiency: Improves waste water ratio and membrane performance. Noise-Reducing Design...

www.bulkreefsupply.com

Any and all advice is greatly appreciated in advance

 

[Sisterlimonpot]

Unless they changed the power supply, that one plugs directly into an outlet, so no need to print a holder for it

 

[fish101]

My bad. I was referring to the power brick.

 

[Sisterlimonpot]

I'm not tracking... what power brick?

 

[Sisterlimonpot]

Nvm, I watched the video and see that they offer a different power supply than the one I have...

All the same, if you get it and no one has came up with a link, provide me some measurements and I can extrude some rectangles and design a holder for you...

 

[fish101]

Bump.