3d printed media basket?

[H2OHenry]

Any one every try 3d printing a media basket? Setting up a Nuvo 20g peninsula and considering trying it out.

 

[crusso1993]

Any one every try 3d printing a media basket? Setting up a Nuvo 20g peninsula and considering trying it out.

There are a few 3D printing threads and a couple are quite active. You'd probably get some action on your question if you ran a search and then posted your question in one of those threads. Simply a suggestion...

I'm also going to tag a couple of 3D printing guys for you here... @JDowns and @dantimdad

 

[dantimdad]

There are plans on thingiverse

Also I believe there was someone here who printed one

 

[Glitchy93]

I made a filter floss holder for my lagoon 25, I believe the it should fit in the IM20 without scaling.I've been meaning to make a full blown media rack so I can run purigen, I just didn't get around to it yet. If someone else has a plan for one I also would be very interested in it.

I know it's not exactly what you were asking for, but hope it helps [emoji106]

Link to the floss holder on the thingiverse: https://www.thingiverse.com/thing:2611072

 

[dantimdad]

I made a filter floss holder for my lagoon 25, I believe the it should fit in the IM20 without scaling.I've been meaning to make a full blown media rack so I can run purigen, I just didn't get around to it yet. If someone else has a plan for one I also would be very interested in it.

I know it's not exactly what you were asking for, but hope it helps [emoji106]

Link to the floss holder on the thingiverse: https://www.thingiverse.com/thing:2611072

Nice!

 

[H2OHenry]

There are a few 3D printing threads and a couple are quite active. You'd probably get some action on your question if you ran a search and then posted your question in one of those threads. Simply a suggestion...

I'm also going to tag a couple of 3D printing guys for you here... @JDowns and @dantimdad

Thanks. I saw a few of the threads and wasn't sure of the best place to post.