3d printed vortech mp10 cover

[AC1211]

Anyone have a good templete for a vortech mp10 nem guard that is better than the foam one and will stay on?
The foam guard is good but after 2 months it either consistantly slipped off or was covered in algae way too quickly.

 

[AC1211]

Anyone?

 

[NeonRabbit221B]

Ecotech Vortech MP10 powerhead screen by doc1013

This is a protective screen for an Ecotech Vortech MP10 powerhead. Its a snug fit to keep the screen connected to the wet end. Provides protection without the constant plugging up of the stock mesh screen which reduces pump flow.

www.thingiverse.com

 

[AC1211]

Ecotech Vortech MP10 powerhead screen by doc1013

This is a protective screen for an Ecotech Vortech MP10 powerhead. Its a snug fit to keep the screen connected to the wet end. Provides protection without the constant plugging up of the stock mesh screen which reduces pump flow.

www.thingiverse.com

One review said it is a bit too small. Is that true or is this appropriate?

 

[AC1211]

I am unable to open the downloaded file on autocad what do I do?

 

[NeonRabbit221B]

For my printer (Prusa MK2S) I generally just open the files in slic3r to convert the stl files into gcode. If size is an issue I would scale 1% up. What printer are you using?

 

[NeonRabbit221B]

It opened fine for me in Autodesk Fusion so I can say its likely not corrupted.

 

[AC1211]

It opened fine for me in Autodesk Fusion so I can say its likely not corrupted.

Ok, thank you. I still have to figure out which of the 3 or so printers available to me I want to use.