I will be absolutely amazed if this thing holds water. This was an absolute comedy of errors.
First I tried to cut a small hole in the tube so it comes out slower for me to control. Cut the tube and start pumping, next thing you know it is spraying like a fountain. Quick clean up! Ok use what landed in the tank to spread by hand before resuming and getting it where it belongs. Good job.
Make my bead, but think it is still to thick so there is way too much extra.
Not so bad, not the neatest but when I removed the tape it shouldn't look so bad. Wait a few minutes and pull the tape because it needs to be pulled when wet.
Baffle slips and slide all over tape hits the side wall depositing silicone where it does not belong, actually right where the next baffle goes so I have to clean up, all the while trying to get the baffle back to being square. All the silicone pushes out of one side so now im trying to press it back in.
Smear lines every where, globs everywhere, paper towels covered in silicone everywhere.
I'm stressed I'm getting a beer!
Oh I have two more baffles to complete still. I'm not sure I bought enough silicone for this job!
SMH what the heck ROTFLMAO LOL (I'm sure there are more but I'm too old for that kind of talk)
