425xl with cor-20 manifold design feedback?

[danR777]

Is there anything wrong with this manifold design? Not sure what else I can do?

It’s going in a 425xl with a COR-20 return

it’s 1” from return and going to 1/2” gate valves and the top is 3/4” barb….

 

[blaxsun]

Is the 3/4" barb for the COR to connect?

 

[danR777]

Is the 3/4" barb for the COR to connect?

the big union at the bottom is where the car-20 screws in .. the big barb connects to the tank...

 

[blaxsun]

the big union at the bottom is where the car-20 screws in .. the big barb connects to the tank...

You may find you want the manifold directly connected to your plumbing for maintenance (so that when you remove the COR the manifold stays in-place).

 

[danR777]

that make sense, thank you, thank you