72x30x18 DIY build thread

[Nate Chalk]

?

That was last night.

I think the correct way to reseal a tank is to remove all panels and redo....

I think imma try since its small to just reseal the new panel in. Might be a fail. Might not be :s

 

[Projects with Sam]

That was last night.

I think the correct way to reseal a tank is to remove all panels and redo....

I think imma try since its small to just reseal the new panel in. Might be a fail. Might not be :s

glad to hear you're moving things along!

 

[rmorris_14]

glad to hear you're moving things along!

I find this comment personally passive aggressive.

 

[Nate Chalk]

I find this comment personally passive aggressive.

Get it in gear. Imma have this tank set up and wet here soon

 

[Nate Chalk]

Hawt baby hawt

 

[Nate Chalk]

Well.... They drilled the holes in the wrong spot. .. waiting to hear back now

 

[rmorris_14]

Well.... They drilled the holes in the wrong spot. .. waiting to hear back now

I refer you to your previous statement "Get it in gear. Imma have this tank set up and wet here soon"

 

[Nate Chalk]

I refer you to your previous statement "Get it in gear. Imma have this tank set up and wet here soon"

Welp. Now im deflated.

 

[Projects with Sam]

Well.... They drilled the holes in the wrong spot. .. waiting to hear back now

looks like the bulkheads wont even fit.

 

[rmorris_14]

Welp. Now im deflated.

:oints up::::this is reefing.

Surprised you ,didn't I

 

[Nate Chalk]

looks like the bulkheads wont even fit.

They fit, I do need to take a couple mm off the sides of the panel... figuring out the best technique for that... might be able to salvage. Prefer them to just get me another piece.

 

[Nate Chalk]

::oints up::::this is reefing.

Surprised you ,didn't I

I feel like I just competed in Royal rumble. Got down to the finals and lost the Superbowl.

 

[fishguy242]

looks like the bulkheads wont even fit.

K Y ...?...

 

[Nate Chalk]

The intended orientation,
The maybe salvage. But would need to run elbows to height. Resulting in ugly execution.

 

[Projects with Sam]

They fit, I do need to take a couple mm off the sides of the panel... figuring out the best technique for that... might be able to salvage. Prefer them to just get me another piece.

sand it of on emery paper

 

[Projects with Sam]

ooof.. that's a replace.. they messed-up.

 

[Projects with Sam]

ooof.. that's a replace.. they messed-up.

hell; I'll send you a piece before I let you do that to yourself.

 

[Nate Chalk]

They are reaching out to fabricator to remake the piece. 5 minute response time they are right down the road. First time working with them. Like it already.

Yeah the piece is tough because the holes are so close. Trying to save as much room in the little tank as I can.

 

[fishguy242]

The intended orientation,
The maybe salvage. But would need to run elbows to height. Resulting in ugly execution.

Take it back , tell them you'll be in car waiting, this is for a job!!

 

[StatelineReefer]

While you're at it, ask them why they felt it was acceptable to give ANY customer, much less a first time customer, a piece that was off-spec and out of tolerance.