Adding a clarisea (sk 3000 or sk 5000) to a trigger sump 26

[Ayrity]

Hey all, I want to add a clarisea to my sump, but as you can see, I'm not sure if I have room. How would you go about doing this? I read you can hang them off the sides of a sump, I assume it has to be inside the sump not hung off the outside right? I dont think I can cut the filter sock area out of this sump, the rim around that area is all solidly fused to the rest of the sump trim. Most of that first chamber is taken up by the skimmer. Any ideas? Thanks!

 

[Snoopy 67]

If you can move the skimmer to the center section it would probably fit.
It does have to be in water & sizing is done by flow rates.
The drain line hooks up to the unit & the unit must be removed to change the roll.