So I bought a new nyos 120 skimmer and I want to add a drain mostly because I get lazy and don’t want to clean the cup every few days. And I’m trying to find some hardware to use. I was going to go with a 3/8 ro quick fitting, but I can’t find one with a nut on it, also it needs to be a 90 degree fitting. Has any one done this and if so what fitting did you use? Thanks in advance for the advice.
Adding drain to nyos 120 skimmer
- Thread starter stez
- Start date
- Tagged users None
Scottydo
New Member
- Joined
- Jan 11, 2022
- Messages
- 6
- Reaction score
- 0
- Location
- Loveland
- What state or country do you live in
- Colorado
Were you able to find the correct part? I have the same nyos 120 and as you know there is not much room. If you were able to do this can you tell what exactly what you
went with and where you got it? Did it work ok? Thanks!!!
Reckless
Community Member
- Joined
- Dec 13, 2021
- Messages
- 38
- Reaction score
- 27
- Location
- Bay Area
- What state or country do you live in
- California
All you need is a Drill Tap bit, maybe some Teflon tape and RO elbow fitting like the ones listed below.
www.bulkreefsupply.com
www.bulkreefsupply.com
Mur-lok Swivel Elbow 1/4" NPT x 1/4" Push Connect
Mur-lok Swivel 90 Degree Elbow 1/4" Mur-lok RO fittings are the only RO fittings that feature dual EPDM O-rings to ensure a straight leak free fit. We assemble our Reverse Osmosis units and Media Reactors virtually exclusively with Mur-lok fittings. These high quality American made fittings are...
www.bulkreefsupply.com
Mur-lok RO Elbow - Male NPT x Push Connect
Mur-lok RO fittings are the only RO fittings that feature dual EPDM O-rings to ensure a straight leak free fit. We believe GA Murdock Mur-lok fittings to be the best so strongly that we use them virtually exclusively on each of our BRS reverse osmosis systems and BRS media reactors. These high...
www.bulkreefsupply.com
