AI Vega help
- Thread starter SaltyKoi
- Start date
- Tagged users None
dcraigj
Active Member
To reset the light to factory state/firmware:
1. Hold down the red button on the side of the light
2. Remove the power jack from the light itself
3. Push the power jack back into the light whilst still holding in the red button.
4. Release the red button.
This will reset the light unit, you will now need to set the unit back into discovery mode :
If you had a controller.
1. Hold in the red button on the side of the unit
2. Keep the button held in for around 5-7 secs and until the status LED flashes red/green rapidly
3. Release the button and the status LED will turn solid red denoting that the light is in discovery mode and will be found by either the MK II controller or Director when searched for.
4. The light unit will then be updated to the latest firmware once connected to the controller/director
1. Hold down the red button on the side of the light
2. Remove the power jack from the light itself
3. Push the power jack back into the light whilst still holding in the red button.
4. Release the red button.
This will reset the light unit, you will now need to set the unit back into discovery mode :
If you had a controller.
1. Hold in the red button on the side of the unit
2. Keep the button held in for around 5-7 secs and until the status LED flashes red/green rapidly
3. Release the button and the status LED will turn solid red denoting that the light is in discovery mode and will be found by either the MK II controller or Director when searched for.
4. The light unit will then be updated to the latest firmware once connected to the controller/director
dcraigj
Active Member
If there is no controller present I don't believe a program is stored. With out a controller you are only able to change the intensity.
Vega was designed with basic controls by pressing the red button you may cycle through intensities of 1, 20, 40, 60, 80, and 100 by pressing the red button. You may only use this mode if the Vega is not being controlled by a controller.
Vega was designed with basic controls by pressing the red button you may cycle through intensities of 1, 20, 40, 60, 80, and 100 by pressing the red button. You may only use this mode if the Vega is not being controlled by a controller.
