Alk stable but low

[Marinereefiner]

Hello,

I have started a tank almost 1 year ago. My Alk has been consistently around 6.4 Dkh. I’m looking to raise this up slowly. Does anyone have any luck doing this without swinging the other parameters?

Salinity: 1.025
Temp: 79
Ph: 8.0 to 8.2
Dkh: runs around 6.4
Nitrate: 50
Phosphate: 0.03
Calcium: 450

TIA

 

[Joe31415]

Soda Ash, or, the alkalinity part of two-part. It'll temporarily bump your pH a bit, but that's about it.

Pharma Soda Ash 1-Gallon Mix (5 Pack)

Ultra-pure Grade Soda Ash for 2-part dosing in your reef tank! Bulk Reef Supply 2-part additives are the perfect solution to replenish the intake of calcium and alkalinity coral consumes when it grows. Using only pharmaceutical grade ingredients allows you to keep a cleaner reef with fewer...

www.bulkreefsupply.com

Your local fish store might carry this exact brand if they have other BRS products, but if not, just make sure you're buying something that's just soda ash (or sodium bicarbonate, if you use that instead). Products like All For Reef are, by design, going to raise calcium as well.

 

[Joe31415]

Also, do you have any corals in there yet? If you don't have anything consuming the alkalinity and it's just naturally at 6.4 (test the fresh/unused saltwater), you might want to look into switching salt brands. I'm only familiar with my brand that happens to run exceptionally high, but if your fresh saltwater is running that low, it seems like it's going to be an uphill battle to maintain once you start adding things. But that's a moot point if it's low because you've already started stocking it with alkalinity consumers.

 

[Randy Holmes-Farley Verified Community Expert]

Baking soda is a fine way to boost alk and little else.

 

[Pistondog]

Baking soda as Randy said. 2 teaspoons will raise the alk in my 100 gallons 7.4 to 7.7 dkh.

 

[Marinereefiner]

Thank you All for you insight.

I do have some corals in the tank.

I’m using Fritz RPM salt. I will take a sample of fresh saltwater

Any known issues from dosing with baking soda? Is baking soda a temporary resolution or do I just dose with it when needed?

 

[Randy Holmes-Farley Verified Community Expert]

Thank you All for you insight.

I do have some corals in the tank.

I’m using Fritz RPM salt. I will take a sample of fresh saltwater

Any known issues from dosing with baking soda? Is baking soda a temporary resolution or do I just dose with it when needed?

It is not temporary or second rate. It is just cheaper than a commercial buffer.

 

[Marinereefiner]

It is not temporary or second rate. It is just cheaper than a commercial buffer.

He

Also, do you have any corals in there yet? If you don't have anything consuming the alkalinity and it's just naturally at 6.4 (test the fresh/unused saltwater), you might want to look into switching salt brands. I'm only familiar with my brand that happens to run exceptionally high, but if your fresh saltwater is running that low, it seems like it's going to be an uphill battle to maintain once you start adding things. But that's a moot point if it's low because you've already started stocking it with alkalinity consumers.

I checked my fresh saltwater. It is running at 8.34 Dkh. Something must be using it.

 

[Randy Holmes-Farley Verified Community Expert]

He

I checked my fresh saltwater. It is running at 8.34 Dkh. Something must be using it.

If your nitrate measurement is accurate, the alk was depleted by 2.3 dKH due to the accumulation of that 50 ppm of nitrate.