Anemone and torch dying
- Thread starter CaseyLee
- Start date
- Tagged users None
PO4 0.1
NO3 15
Cal 400( abit low)
Mg 1350
Kh 8 (low?)
PH 7.8 (low)
Will track again later...
I dose kh, and cal.
All the coral are doing well,
There's a time anemone stick on my torch. And both of them stung each other maybe?
(I think it's not the plankton / or.new coral problem?)
my torch (3 heads) and two had gone I gently brush off the flash =(
NO3 15
Cal 400( abit low)
Mg 1350
Kh 8 (low?)
PH 7.8 (low)
Will track again later...
I dose kh, and cal.
All the coral are doing well,
There's a time anemone stick on my torch. And both of them stung each other maybe?
(I think it's not the plankton / or.new coral problem?)
my torch (3 heads) and two had gone I gently brush off the flash =(
well your parms seem ok. I don't see any issues. Your DKH is fine. Your Ph could be raised a bit, but it depends on when you took the tests. Your PH will swing up and down from day to night. If your PH is 7.8 during the day, then that means its probably around 7.5 at night so it needs to be raised and buffered up slowly.
Yeah it looks like the anemone is moving around and not happy. Could be the PH. It will take out the clam too if you let it stay there.
Yeah it looks like the anemone is moving around and not happy. Could be the PH. It will take out the clam too if you let it stay there.
