Any 3D printer owners have the capability to make me a custom cradle?

[Manny’s Reef]

Looking to see if any of you 3D printer owners out there can help make me a custom cradle for my XF350 gyres. The magnets just will not stick to my glass. They worked for a very small time but then they stopped holding in place. I contacted CoralVue who sent me an extra magnet to double up on the inside magnet with. This solution did not work. I paid too much money for these pumps not to be using them. So, ideally, I'd find someone who can 3D print a cradle that hangs over the glass and lowers the pump into the aquarium about 5". Thanks in advance.

 

[neonreef3d]

Yes… PM me… I remember you ordered some kessil mounts in the past..

 

[Manny’s Reef]

I’ll PM you sometime this weekend.

 

[Manny’s Reef]

PM sent

 

[Manny’s Reef]

Is there anyone else available to make 3D printed parts? I'm not sure what happened to the above member but I have not heard back from him anymore. He printed a custom kessil mount for the ecotech rail mount. I'm needing another one. Looking for someone to make me one.
Really wish Neon Reefer would respond because his product was amazing.

 

[neonreef3d]

Is there anyone else available to make 3D printed parts? I'm not sure what happened to the above member but I have not heard back from him anymore. He printed a custom kessil mount for the ecotech rail mount. I'm needing another one. Looking for someone to make me one.
Really wish Neon Reefer would respond because his product was amazing.

I just sent you a message.