Any Ideas

[msman825]

On how to put a hole in a G-3 collection cup for a drain.

 

[twon8]

you really should use a tap, so it will be threaded and you can screw in an elbow.

 

[msman825]

I'll drill me a 1/4 inch pilot hole, then tap it to 3/8's It's not very thick though

 

[msman825]

I'll tell you in a few

 

[organism]

I did the same thing with my g4, slowly drilled a hole, then glued in a 90 degree elbow with silicon glue, worked out nicely

 

[msman825]

well got it drilled. man its thin I started a hole with a 1/8 and worked my way up to a 3/8 tapped hole. Going to see what i can find threaded tomorrow to fit in there, Thank you guys for the advise. Let you know tomorrow when i get home from lobstering what i came up with thanks again

 

[organism]

not to hijack the thread, but msman where do you do your lobstering? I'm out bugging like 4-9 times a week

 

[jessiesgrrl]

LOL

He does it in Maine... He's a good ol' SWAM member... Nice guy!

I hope you are keeping warm in these winds while you are out on the boat...

:love2:
Laurie