Okay i upgraded my tank to 80 gallons the drain line was 1 1/2 inch and I reduced to 1 inch is it going to case a lot of problems ? I didnt know or think i was able to add a tie on the 1 1/2 and spilt it into 1 inch on my sump should i empty the water out and redo the whole thing ? Plz help
Any suggestions?
- Thread starter edmond
- Start date
- Tagged users None
mcarroll
10K Club member
The extra size of the original drain is probably to keep it quiet and as a form of reserve so there's plenty of extra capacity in the event of a partial blockage.
Why did you reduce the size of the drain line? Ideally never restrict the drain.
If it was just for the connection to the sump, then personally I'd redo it without that connection. Hopefully that connection isn't necessary tho.
Are those check valves in the one photo? What are those in the design for?
Why did you reduce the size of the drain line? Ideally never restrict the drain.
If it was just for the connection to the sump, then personally I'd redo it without that connection. Hopefully that connection isn't necessary tho.
Are those check valves in the one photo? What are those in the design for?
I got the whole tank setup like that im new to overflows so I didn't know I reduced it because i didnt know i could tie of to 2 holes on the sump for the 2nd qs yes they are check valves it was designed like that
mcarroll
10K Club member
Unless the sump is too small to hold your overflow water when the power is off, I'd probably remove the check valves. I'd at least test it that way (unless you can't get in there to remove them very easy).
