Anyone know which part to order for rodi fitting?

[dedragon]

A piece broke off on my unit and i need to get it replaced just not sure which murlock fitting. I have a brs value 4 stage unit and it is on the di resin cartridge as shown in the picture. I think it should be 1/4 threaded to 1/4 murlock right like this one?

Mur-lok RO Elbow - Male NPT x Push Connect

Mur-lok RO fittings are the only RO fittings that feature dual EPDM O-rings to ensure a straight leak free fit. We believe GA Murdock Mur-lok fittings to be the best so strongly that we use them virtually exclusively on each of our BRS reverse osmosis systems and BRS media reactors. These high...

www.bulkreefsupply.com

 

[dedragon]

.

 

[Snoopy 67]

Take the broken fitting out to make sure it's threaded & then I think you are correct.

 

[SPS2020]

I think that is 3\8" NPT to 1\4" push. Give BRS a call to be sure! ;-)

 

[dedragon]

i got it out, it is 100% threaded at that end

 

[LeftyReefer]

BRS units have lifetime warranties, don't they? Maybe give them a call and maybe they will just toss one in the mail for you.

I'd guess it's probably a 1/4" thread.

Most RO canisters have 1/4" threads... you can get canisters with larger ports, like 3/8" or 1/2" but those are typically used for reactors and such with higher flow.

membrane housings have 1/8" thread

 

[Biglew11]

That's a 1/4 npt pipe thread. If you need it right away you can get it at lowes or home depot.

 

[dedragon]

they got back to me at last, it was the 1/4 to 1/4" piece, thank you all for the help

 

[Big Smelly fish]

You can fine at home depot or Lowes. I have pick a few up in the past.