Tab28
Valuable Member
I recently got my Jebao WP-40, but have not set it up yet. I was wondering if someone has experience with the modes. I have the newer 12 modes controller. I also purchased the optional voltage regulator.
I am interested in either using the W1 or the else mode. But my question in basically the else mode. The instructions state the S1-S3 which are the speeds are used for the W1 mode and with the timing wheel to fine tune your wave on off pulse. Once you get what you like you can lock both in. The speed and timing wheel are only used in the W1 Mode? If I turn the else mode on, which actually is the same as the Red Sea Wavemaker I am now using. It cycles through all the modes. If that is the case will the W1 mode resort back to the factory speed and timing in the else mode. When it gets to the other modes while cycling will the pump hit maximum speed reached since the S1-S3 are only for the W1 mode.
I am interested in either using the W1 or the else mode. But my question in basically the else mode. The instructions state the S1-S3 which are the speeds are used for the W1 mode and with the timing wheel to fine tune your wave on off pulse. Once you get what you like you can lock both in. The speed and timing wheel are only used in the W1 Mode? If I turn the else mode on, which actually is the same as the Red Sea Wavemaker I am now using. It cycles through all the modes. If that is the case will the W1 mode resort back to the factory speed and timing in the else mode. When it gets to the other modes while cycling will the pump hit maximum speed reached since the S1-S3 are only for the W1 mode.
