Apex code dealing with power

[becon776]

Tried posting this in general but no bites figured this was more appropriate.


Hi guys. So my return is acting weird. Out of nowhere it will almost shut itself down. Power reports say 3w. Normally runs at 64. When this happens I shut pump off then back on again all is fine BUT i notice i have burned thru half a roll of filter mat. I know I know get a better return. Also id rather not mess with the float valves as all are set perfect for the status quo. But for right this is the code I came up with. Is this right? If there is a cleaner way?

Fallback ON
Set ON
If Output Jeboa_Return = OFF Then OFF
Defer 002:00 Then ON
Fallback OFF
Set ON
If Output Jeboa_Return watts < 20.0 Then OFF
Defer 010:00 Then ON
If Power Apex Off 001 Then OFF
Defer 002:00 Then ON
If FeedA 005 Then OFF
Defer 002:00 Then ON

 

[blaxsun]

1. I'd look at replacing your return pump if this is the case.
2. I might change the Defer time on line 8 to 001:00 instead.

@SuncrestReef

 

[becon776]

Looking to clean it up. Seems like there are too many Defer and set and fallbacks