Apex coding trouble

[lubeck]

I’m trying to follow the tutorials on adding a virtual maintenance program. I was able to add the code to my DOS but cant add it to my return pump, mp10 or heater because I don’t see the advance tab when going into the output section, what am I doing wrong?

 

[SuncrestReef]

You just need to change the Control Type on each of those outputs to "Advanced" to reveal the code window. Look at my tutorial on Control Types for more details and screenshots:

Apex Control Types

When I wrote my 8-part Apex Programming Tutorial series, all of the coding examples were applied to outputs where the Control Type was set to Advanced. Control Types are pre-set shortcuts to program an output for a specific device, allowing less...

www.reef2reef.com

 

[lubeck]

You just need to change the Control Type on each of those outputs to "Advanced" to reveal the code window. Look at my tutorial on Control Types for more details and screenshots:

Apex Control Types

When I wrote my 8-part Apex Programming Tutorial series, all of the coding examples were applied to outputs where the Control Type was set to Advanced. Control Types are pre-set shortcuts to program an output for a specific device, allowing less...

www.reef2reef.com

Very helpful thank you

what do I need to do to this code so it works? But I want to add another code to my kalk dos that if salinity goes below 34.9 to turn off