APEX DOS and WAV using 1link and Power Log

[Da Ghost]

Greetings,
As the title implies, I have a set of WAV powerheads and a DOS hooked via 1link cable directly into the energy bar, but now I would like to see the Power log or power consumption chart for those items.

I can not find it. While i see the Power log and all items that are plugged in via traditional plugs, I do not see the 1link items and would like to see those.

Can any one assist??

I am getting ready to set alarms for my items when watts used drops past a designated number to 'hopefully' alert me. My hope is this will let me know when something is going bad, dying or having difficulty producing the watts it has typically produced. Any help would be appreciated.

 

[DLHDesign]

Sadly, I don't believe that the 24v plugs in either the energy bar nor the 1LINK module allow for power monitoring.

I took a look to see if the "total power" reflected the power draw from these ports, but I didn't notice that they registered. Not that it being included would really do any good, but I think it supported the point that the ports aren't monitored. Boo. :-\

 

[Da Ghost]

I was afraid you would say that. BUT glad you chimed in. I too looked at the total output and then subtracted items hoping it might be there, but nope it does not seem to be. Thank you very much.

Thank you!!