Sep 17, 2020 #1 B Biff0rz Valuable Member View Badges My Tank Thread Joined Jul 9, 2020 Messages 1,773 Reaction score 966 Location USA Rating - 100% 2 0 0 I ran calibration on one of my apex dos. One of the heads output 38ml. The other output 16ml. I entered that into fusion but that seems quite low.. Is the head bad?
I ran calibration on one of my apex dos. One of the heads output 38ml. The other output 16ml. I entered that into fusion but that seems quite low.. Is the head bad?
Sep 17, 2020 #2 Biglew11 Valuable Member View Badges My Tank Thread Joined May 10, 2020 Messages 1,577 Reaction score 1,885 Location New York Rating - 0% 0 0 0 Check the lines for clogs. Or possible air leak somewhere.
Sep 17, 2020 #3 OP OP B Biff0rz Valuable Member View Badges My Tank Thread Joined Jul 9, 2020 Messages 1,773 Reaction score 966 Location USA Rating - 100% 2 0 0 The lines are new and short (2ft) and I primed it. The only place air would be would be if the line in the head had a hole
The lines are new and short (2ft) and I primed it. The only place air would be would be if the line in the head had a hole
