Apex Dos programming
- Thread starter reeferdon
- Start date
- Tagged users None
ZombieEngineer
Valuable Member
You didn't give much information to work with. If you want to add a specific volume, just use the wizard and split that over 24 hours.
If you want to use it as a pseudo ATO, we need more info.
If you want to use it as a pseudo ATO, we need more info.
gbru316
Well-Known Member
Neptune has guides for all of their devices, and a comprehensive guide that goes into lots of detail about the Apex itself.
it would be of your benefit to utilize said resources.
it would be of your benefit to utilize said resources.
OP
OP
reeferdon
Active Member
I did the get started and the task drop-down and nothing. my dose is new. So what I'm trying to do is set pump 1 to dose Kalkwasser on a 24hr dose. pump 2 to dose RO water into the Kalk container.
It's not allowing me to add the second interval.
Also, I'm not sure about this code that's from the task menu, I didn't input it in there.
It's not allowing me to add the second interval.
Also, I'm not sure about this code that's from the task menu, I didn't input it in there.
Attachments
gbru316
Well-Known Member
You cannot set both to run from the same screen.
you need to select one dosing head for kalk and set the schedule.
then select the other dosing head for RO, and set its schedule.
The code is from the task wizard. Don’t touch it.
you need to select one dosing head for kalk and set the schedule.
then select the other dosing head for RO, and set its schedule.
The code is from the task wizard. Don’t touch it.
