Well I’m starting to think the Apex just isnt robust. I had my apex working for a year and decided to make a controller board. So I had to disconnect and reconnect everything. What a disaster! Took me hours just to get my two tanks back online. And now one EB8 and my WXM module aren’t working. So that means no flow or lights for both my tanks. Tried resetting and removing modules but doesn’t work. Removed the WXM module but doesn’t show back up. Just blinks yellow. If I connect the third EB8 it basically shuts down the system. Really disappointed due to the cost of the system. Any recommendations for a better controller? Might have to consider it if I can’t get it working again.
Apex issues.
- Thread starter emoore
- Start date
- Tagged users None
elcapitan1993
Well-Known Member
This same exact thing happens to me when I set it up in my adaptive reef board, i found out that the plugs are horribly soldered on and needed to be resoldered, after that I smashed all my Neptune stuff with a framing hammer and bought GHL stuff , Neptune plastic feels cheap and toy like, and if you open up the apex unit you will see how poorly all the components are attached, I’m willing to bet that’s your problem
This is far from common. While it’s all just personal experience, I’ve got 7 year old Neptune gear going strong with zero issues and been moved all over the place. Different tank, different houses, now my buddy has it and still no issues.
GHL makes great hardware with terrible software.
GHL hardware and Neptune software would be the killer combo
GHL makes great hardware with terrible software.
GHL hardware and Neptune software would be the killer combo
seant2h
Active Member
Is this an apex classic? I have one that used to be ok being powered over usb from the eb8 but that went sideways one day and I moved on.
After reading some threads I discovered that the main unit should be powered by a 12v adapter so if you have an apex classic and don’t have it powered by a 12v plug then maybe try that. I’d also recommend plugging the WXM aquabus cable directly into the eb8 and not the main head in case this is a power issue.
After reading some threads I discovered that the main unit should be powered by a 12v adapter so if you have an apex classic and don’t have it powered by a 12v plug then maybe try that. I’d also recommend plugging the WXM aquabus cable directly into the eb8 and not the main head in case this is a power issue.
Ok I think I got it all back. WXM is still busted but I reset the lights and pump and am now using Mobius. For those that have radions do you keep them powered all the time or turn them off after the lights go out?
Doesn’t the fan run all the time then? That’s why I switched them off on the apex after the lights went out.
I think after this issue and previous issues with the PMUPs, EB8, WAV I’m going to divest a bit from APEX. I do really like the control and automation but I’m a bit disappointed with the hardware reliability.
It sounds to me like you have/had an aquabus cable that was shorted. Did you investigate this notion? Use process of elimination to confirm this?
elcapitan1993
Well-Known Member
I agree Ghl software sucks so bad
