Aqualink v2 on pulse mode on CP-150

[OnPointCorals Verified Sponsor]

Hello. Is anyone using powerheads on the S1 or T1 v2?

I am using the Aqlink v2 app on my ios. I'm trying to figure out how to set the pulse to a fraction of a second. It looks like the lowest it can be set is 1 second which is way too long. I even try to copy and paste 0.5 and it looks like it takes but then shows as '1'.

You have to be able to set it to less, no?

 

[Reefing Madness]

 

[OnPointCorals Verified Sponsor]

ha thank you. Can't believe I have gotten no comments on this. Is no one using the t1 and S1 controllers

 

[tastyfish]

Sorry guys, I'm using CP-40's on AQLink A1's connected to my Apex so there's probably not much relevance to you using the iOS app. But happy to test if the pump supports it, if it helps

 

[tastyfish]

Just to follow up, the minimum "On" time on the Apex is 1 second also.

Why do you want such short an on time? I found I could produce anything I wanted by changing the power and the on time. The pumps do need to spin up also, they're not propellor pumps.

 

[OnPointCorals Verified Sponsor]

Just to follow up, the minimum "On" time on the Apex is 1 second also.

Why do you want such short an on time? I found I could produce anything I wanted by changing the power and the on time. The pumps do need to spin up also, they're not propellor pumps.

In a 4' tank 1 second or more cannot create a wave. I am coming from using the JBwave controller where you can set it in the 1/10 of a second. I mean even the stock controller you can set it low enough (less than 1 sec) to produce a wave.

 

[tastyfish]

In a 4' tank 1 second or more cannot create a wave. I am coming from using the JBwave controller where you can set it in the 1/10 of a second. I mean even the stock controller you can set it low enough (less than 1 sec) to produce a wave.

Have you used the same pumps with that wave controller? They're not designed to create tiny little waves, they are designed to move chunks of water in a wide flow. Honestly, they won't even have spun up properly in say half a second.

 

[OnPointCorals Verified Sponsor]

Have you used the same pumps with that wave controller? They're not designed to create tiny little waves, they are designed to move chunks of water in a wide flow. Honestly, they won't even have spun up properly in say half a second.

Yes. I just double checked after you wrote this. I have the CP-150 on the Aqualink t1 v2 on one side and on the other side of the tank I have the CP-55 on the stock controller.

I tested the cp-55 on w1 I can make a big wave with it using a short pulse (much shorter than 1 sec on 1 sec off).

I mean this isn't a deal breaker I am using the schedule and most of the day I am using the Reef Mode, but I wanted it to have a wave for a couple hours a day.

 

[Krheigh]

Waking up this thread
I just gott a AQLink t1. I having problems with the AQLink v2 app on both iOS and Android

iOS app doesn’t let me connect to WiFi,
If I add pump manually it crashes, if I enter settings it crashes,

android app works slightly better but Crashes when I Press send to pump

If I use the AQLink app it works but doesn’t support my pump (cp-150)

any thoughts?