Not sure if this is the right place for this thread or not...if it isn't let me know. I have an aquapod 24 that been running for almost a month now. All my numbers are perfect and my fish are healthy (had a very quick cycle). My problem is getting the back chambers where they need to be. I've researched but haven't found anything too useful that I haven't tried already. I've replaced the sliding black pieces for chamber one with a solid piece of plexiglass that runs the full length with an inch open at the top for a better overflow/surface skim. I have filter floss blocking the inlet in the middle of chamber 1:2 but it's very loud as it results to a trickle. On the bottom in have the lower hole filled with a bag of carbon. I'm contemplating changing the carbon to my purechem bag to see if that helps slow flow from chamber 1 to chamber 2. Overall it's where I'd like the levels but it's just very loud, and if the filter floss gets clogged then the pump sucks air and blows bubbles into my tank. Any ideas for mods?!?
