Knuckles33
Community Member
]I recently bought a used ati 6 bulb dimmable powermodule off someone on RC. Two of the sockets didnt work so I assumed it was the ballast. Upon taking the fixture apart I discovered a wire coming from the power supply/dimmable controller that appeared to be cut, however I can't find the other half anywhere inside the fixture. Is there any solution to fix this other than shipping this back? My thought was to cut back the grey sheathing coming from the power supply to get access to the wire that I can just barely see sticking out of the end. The use a connector between the old wire and a new one I can add. Do you think this might work to save myself an expensive repair?
