ATK flashes red four times

Ippyroy · Jun 4, 2020

I am trying to install an ATK in stand alone. Due to WiFi issues I am not able to set up the Apex yet. I have cycled the FMM several times and after plugging in the power cord it immediately starts flashing red. Does anyone know what I am doing wrong?

Biglew11 · Jun 5, 2020

Have you had the fmm conector to the apex before? if so you may need to reset it.

https://www.neptunesystems.com/getstarted/atk-help/standalonevsconnectedfaq/

also these are the alarm conditions check your sensors

https://www.neptunesystems.com/getstarted/atk-help/ledalarmfaq/#52e52d6af5c2ef1dc

Ippyroy · Jun 5, 2020

I tried all of those. I was hoping for more help. I guess I will just move on. Thanks.

Biglew11 · Jun 5, 2020

Is this a new ato or used? Sensors clean functioning properly. Sensors plugged into the right port, low sensor In port 1high sensor in port 2. High sensor above water? I've had optical sensors go bad.

canadianeh · Jun 5, 2020

Ippyroy said:
I am trying to install an ATK in stand alone. Due to WiFi issues I am not able to set up the Apex yet. I have cycled the FMM several times and after plugging in the power cord it immediately starts flashing red. Does anyone know what I am doing wrong?

Please provide detail information and maybe picture too so we can see how you connect them and etc. Like he previous person said, it could be wrong connections (sensors connected to wrong holes) as this happened to me.