ATO DIY directly into tank

[Gretchacha]

I need to make a reliable ATO for a 30G rimless tank without a sump. Any ideas?

 

[Projects with Sam]

This may do it?

DIY Optical ATO by ReefDudes

https://www.youtube.com/watch?v=-P2ESNLUWmYAutomatic Top Off's are essential to keep the salinity in your reef stable! With so many pricey ones on the market, i figured why not DIY my own for super cheap! (and it works well!!!) Check out the youtube video for build instructions. Parts list is in...

www.thingiverse.com

 

[Projects with Sam]

or this:

Aquarium Trim Float Valve Mount by sbash

This is a solid two part design for a simple ATO on an aquarium where the water level is near the rim. I have used this on several tanks for a couple years now. I use nGen/PETG plastic. Don't use PLA. To use the Sketchup file, simply copy the "ungrouped" model and change the sizes to fit...

www.thingiverse.com

 

[Projects with Sam]

https://a.co/d/1NtHPWw

 

[MERKEY]

If you want to be really lazy and don't care what it looks like.

 

[Projects with Sam]

this is a part for the above mini ATO

Aquarium Bottle Auto Top Off by SeeCoryRun

Rimless to rimmed bottle auto top off adapter.Specifically designed for an Aqueon 20 gallon high, so your rim measurements may vary.The ATO: https://a.co/d/cy7kEq8For my needs It was best in the corner, setup as a peninsula, but that also allowed the support leg to sit on the other side of the...

www.thingiverse.com

 

[MERKEY]

 

[Projects with Sam]

go with that link the amazon one is $~3 more!

 

[Gretchacha]

This may do it?

DIY Optical ATO by ReefDudes

https://www.youtube.com/watch?v=-P2ESNLUWmYAutomatic Top Off's are essential to keep the salinity in your reef stable! With so many pricey ones on the market, i figured why not DIY my own for super cheap! (and it works well!!!) Check out the youtube video for build instructions. Parts list is in...

www.thingiverse.com

Awesome project for my daughter who is in a digital electronics course right now!

 

[Gretchacha]

or this:

Aquarium Trim Float Valve Mount by sbash

This is a solid two part design for a simple ATO on an aquarium where the water level is near the rim. I have used this on several tanks for a couple years now. I use nGen/PETG plastic. Don't use PLA. To use the Sketchup file, simply copy the "ungrouped" model and change the sizes to fit...

www.thingiverse.com

Perhaps my daughter can add this to the circuit and I can install it at a lower level as a backup switch

 

[Gretchacha]

I like this gravity flow idea for the QT tank. Wouldn’t be sufficient for the main tank or a vacation, but also a good backup setup idea for a power outage during a vacation. No battery needed

 

[Gretchacha]

Question. What about a Kamoer dosing pump like MikeyMikeMike uses in this video?I basically have the same set up but smaller.