ATO in AIO

[DarthChaos]

Long time reader.....first time poster.

I have a 32g BioCube - just curious where's best place for my ATO sensor?

I did have it originally in my 2nd chamber - as I found this was the chamber that saw the most fluctuations in water lose....and i wanted to ensure my media racks stayed at a stable level.

I've seen posts about putting it in 3rd chamber - but found my 2nd/3rd chambers seem to maintain a very similar water level...my 3rd chamber doesn't seem to drop much further down than my 2nd.

Just looking for thoughts and advice.

 

[cmoore806]

Is there a way to put it in the display area?

 

[DarthChaos]

Is there a way to put it in the display area?

I have a sensor - and then there's the tube for the top up water itself.

The water level in display doesn't fluctuate much - as it empties into the rear....thats where I see all my fluctuations.

Right now - I have the sensor AND top up tube in my 3rd slot (return). I did have it in 2nd slot....in my fuge rack - till I read fresh top up isn't good for the chateo (doesn't like salitity fluctuations).