ATO Tube Holder? (Nuvo 40)

[CaliberGSD]

What do you all use to hold your ATO tube? I have a tube holder on my probe holder but the problem is it doesn't seem to want to hold it well and I don't like how the tube stick up so high to go behind the tank because its so stiff. (If that makes sense) I also have them probes in the second chamber which the water level is higher and I don't want to start a siphon. I can move it to the middle chamber because I have the ATO sensors hanging there as well as the AI Hydra holder there. Maybe if I could find a small enough device that just holds the tube there and nothing else? Also is there a more flexible tube that I could use rather than the very stiff 1/4" line? Trying to stay with a clean look as much as possible. Thanks all!

 

[Bayareareefer18]

What about just a couple push connect 90s to keep it tight against the tank?

Or maybe airline tubing ?

 

[ndrwater]

Try looking at BRS and look up dosing tube holder. Or something similar. There has to be SOMETHING out there to meet your needs.
Worst case, you could always DIY something

 

[CaliberGSD]

What about just a couple push connect 90s to keep it tight against the tank?

Or maybe airline tubing ?

ugh why didn't I think of this! Great idea. Thanks!

 

[Bayareareefer18]

There are also really inexpensive dosing tube holders that have a thumb screw you can tighten down. Amazon is your friend

 

[Selk Oner]

Kulk reactor works perfectly

 

[CaliberGSD]

Kulk reactor works perfectly

I’m not following what your trying to say.