Baffles

[Mockery]

Ok so i cut some baffles out of acrlyic and well they are a little tight. What is the best way to trim them?

 

[Poseidon]

Belt sander?

 

[mhowe9]

I have always just used a table saw. Just wear some eye protection.

 

[Ladipyg]

Make sure to use a fine blade and slow speed (if it's adjustable) or it will just melt back into place. Fine blade keeps it from getting caught and shattering. I guess it depends how much...you could just sand it down.

 

[kgross]

I normally use my jointer to trim just a little bit off.

But a sander will work, and so will a table saw.

Kim

 

[AquaWorldPSC]

Table saw with a blade of at least 80 teeth.