OP
OP
ReefCartel
Well-Known Member
alk is 7dkh (127 ppm)
Calcium Reactor Questions
- Thread starter ReefCartel
- Start date
- Tagged users None
d2mini
5000 Club Member
you are way out of balance. Why is your calc so high?
OP
OP
ReefCartel
Well-Known Member
i believe its aquavitro salt i am using. I checked Ca with hannah. I will try another test kit. Salinity is at 34
d2mini
5000 Club Member
Ya, try another kit out of curiosity.
I use Salinity, too but my Calc is like 420 and Alk around 8.
At least last i checked. I very rarely check calcium since running the CaRx.
But i wouldn't run the reactor until you get that in balance.
You can use baking soda or brs alk mix until the calcium comes down.
I use Salinity, too but my Calc is like 420 and Alk around 8.
At least last i checked. I very rarely check calcium since running the CaRx.
But i wouldn't run the reactor until you get that in balance.
You can use baking soda or brs alk mix until the calcium comes down.
OP
OP
ReefCartel
Well-Known Member
Hey ok my Cal is actually at 430.
OP
OP
ReefCartel
Well-Known Member
Does your effluent line pour into your tank in a constant stream or does it drip?
d2mini
5000 Club Member
430... much better.
My effluent is a kind of pulsing stream. Almost steady.
Just the way the cole parmer pump is pushing it out.
A drip isn't enough effluent for my tank.
My effluent is a kind of pulsing stream. Almost steady.
Just the way the cole parmer pump is pushing it out.
A drip isn't enough effluent for my tank.
OP
OP
ReefCartel
Well-Known Member
My lowest setting on the palmer pushes out a light stream but i noticed some new tanks drip. Hopefully this is good for a 190.
OP
OP
ReefCartel
Well-Known Member
Hey so I finally got to testing my effluent lol so my target Alk is 6.5 - 8 dkh so the hanna stays within my range at 219ppm.
