Cannot assign PAB for new Maxi doser

[Mortie31]

Hello
I cannot get my new Maxi doser to assign to my system, the doser is plugged in the connect lights are lit and the logo is blue, however when I click the assign devices button i can see the correct serial number, but the description is blank, for my other devices it says doser 2:1 etc. If I then check the tick box and continue, it disconnects as usual, then upon reconnecting the device is not assigned and in my list. I’ve been around this loop several times I’m in the new 1.03 gcc and 7.08 firmware. Am I doing some stupid or is there an issue? Hope you can help
Paul

 

[Mortie31]

Bad timing to run into issues just at Xmas lol

 

[Jerel]

You’ll need GCC 1.0.4, which has support for Doser Maxi.

 

[Support@GHLUSA Verified Sponsor]

@Mortie31 - As @Jerel mentioned, you'll need GCC 1.1.0.4 for Maxi Support.

Please download and use that

https://www.aquariumcomputer.com/downloads/ghl-control-center-v1-1-0-4/#changelog

 

[Mortie31]

Thanks chaps, have upgraded to this version and it recognised the doser, unfortunately the doser firmware update it needed after, didn’t work, but I’ll have another try tomorrow

 

[Support@GHLUSA Verified Sponsor]

@Mortie31
GCC 1.1.0.5 has been posted to the download section, included are firmware updates for both PL3 & PL4.

 

[Lasse]

@Marco@GHLUSA I can´t find either 1.1.0.4 or 1.1.0.5 at the website

Sincerely Lasse

 

[Support@GHLUSA Verified Sponsor]

We've pulled offline and will will revisit tomorrow.

 

[Lasse]

Thank you

Sincerely Lasse

 

[Support@GHLUSA Verified Sponsor]

Back up

 

[Lasse]

@Marco@GHLUSA Avast still block the file we speak about earlier

Sincerely Lasse

 

[coweyes298]

Following. Have been using 1.1.0.4 for several days. Did some firmware update too. So far so good.

 

[Mortie31]

Success Marco and Matthias... FW and GCC updated to 7.09 and 1.05. Maxi doser is assigned, named correctly and is configured... now to calibrate it and get it working