Changing lighting... BuildMyLED 20K Reef Spec -> ReefBreeders Photon V2+

will25u

Well-Known Member
View Badges
Joined
Oct 28, 2017
Messages
551
Reaction score
2,967
Location
Georgia
Rating - 0%
0   0   0
Howdy,

1. I just bit the bullet and bought a ReefBreeders 32" Photon V2+. Will be using the stock tank mounts.
2. I am currently running BuildMyLED 20000K Reef Spectrum lights. Sits on top of tank.
3. I have an Innovative Marine Fusion 30L tank(13" depth).
4. I have a mixture of SPS, LPS, and softies.

I need some assistance with light levels. Below are the PAR levels from BML, and ReefBreeders. I know I am taking a big step up in PAR between the two lights, and don't want to hurt my corals. I run the BML(All 3 channels) at 100% for 6 hours, and a ramp up/ramp down before and after.


HosD4JX.png
Par-value-guide-Photon-32-V2.jpg


I am thinking that I don't need to run the new lights higher than about 30% on to get everything acclimated. I know not all the channels should be set to the same brightness, but just looking for any suggestions anyone might have for getting started with my new lights.

Thanks!
 
When I had the 48" I had it mounted at 12" above the tank (75g). The blues were set to 60% with a flat 7 hour burn. One hour rank up and 3 hour ramp down with the UV at a 1.5 hour to 0% , Whites I had from 0 to 33% over 4 hours, held that for an hour then another 4 hour return to 0%. Reds to 7% but one hour after the blues ramp up. This was flat for 5 hours then a three hour to 0%. Greens were off the entire photo period as the 5.5K whites put off enough in that spectrum that they are not really needed. (Per Logan from Reef-Breeders)

This setting at 12" produced very minimal disco or hot spots. Color blending overall at this height was near perfect and minimal shadowing encroaching T5 lighting coverage. At this height and power settings I registered a solid 300-325 par 8" below the waterline and a fairly even 125 par across the entire sand bed. Only dropping to 90 in the corners and across the back wall. This was over a full mixed reef tank and had amazing color pop and very good growth with all my corals.

For your tank being so shallow, you can start by butting the values in half to start. I would highly recommend getting access to a PAR meter. Many local aquarium clubs have them to loan out if you are a member, otherwise you can rent them from online vendors like Bulk Reef Supply and Pod Your Reef.
 
Last edited:
Thank you for being so helpful. I think there’s a place here that’ll rent out PAR meters. I certainly don’t want to cook what I’ve got.
 
So how do you like the photon v2+ vs the BML's? I'm still running 3 bml's plus one orphek strip. The one orphek strip makes the colors really pop more that the bml's.
 

IF YOU HAD TO TAKE A REEFING EXAM, WOULD YOU PASS?

  • Yes!

    Votes: 30 44.8%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 13.4%
  • No.

    Votes: 25 37.3%
  • Other (please explain).

    Votes: 3 4.5%
Back
Top