Clearwater
Active Member
Just got a new set of cutters for fragging sps. What's the proper way to clean these to keep from rusting out? They are stainless but saltwater is the worst enemy.
Last edited:
Cleaning fragging tools
- Thread starter Clearwater
- Start date
- Tagged users None
-Logzor
2500 Club Member
They will slowly get ruined if you don't take action. To prevent rusting, wash them off in tap water. Dry them, then I've even heard of some people keeping them in a tub of rice to absorb moisture.
With very poor care on my end, mine rusted out after about 2 years of use. To fix this I used vegetable oil to loosen then up then later I washed with dish detergent and dried them.
So long as you are diligent with washing them very well (just tap, no soap or anything is necessary) and drying you shouldn't encounter problems.
With very poor care on my end, mine rusted out after about 2 years of use. To fix this I used vegetable oil to loosen then up then later I washed with dish detergent and dried them.
So long as you are diligent with washing them very well (just tap, no soap or anything is necessary) and drying you shouldn't encounter problems.
Last edited:
OP
OP
Clearwater
Active Member
Thanks guys. 
cdness
2006 - Present
Rinse in fresh water after each use. Let them air dry. Do not store them inside the aquarium cabinet where there is high humidity...
If they do get rusted a soak in vinegar, then a soak in veggie oil will loosen them back up again. After this just rinse well in really hot water and use...
I have had the same set of bone cutters for 6 years and they are still going strong using this method. This works for tweezers, bone cutters, and scissors. I don't use scalpels as I frag softies with surgical scissors.
If they do get rusted a soak in vinegar, then a soak in veggie oil will loosen them back up again. After this just rinse well in really hot water and use...
I have had the same set of bone cutters for 6 years and they are still going strong using this method. This works for tweezers, bone cutters, and scissors. I don't use scalpels as I frag softies with surgical scissors.
reefin101
Active Member
I just rinse off with fresh water, shake dry and then let air dry.
Also if cutting out of water, tin snips work much better than bone cutters and are much cheaper!
But if you have to cut in water still with the stainless steel bone cutters
Also if cutting out of water, tin snips work much better than bone cutters and are much cheaper!
But if you have to cut in water still with the stainless steel bone cutters
OP
OP
Clearwater
Active Member
I was just curious if anyone had a secret to keep those things nice and shinny! Will to the rinse and dry really good.
