Cloudy water

Tidal Gardens
Jump to Last
Top Shelf Aquatics
jazreef said:
Yes. Everything has been fine up until a week ago. Not much has changed other than the addition of a couple of crabs as well as the charcoal.
Click to expand...
Ok, so you should have bacteria established in your tank that should be able to keep up with the ammonia, but you may have had the bare minimum that was just able to keep up with the livestock you had before, but maybe since you added the crabs, the bacteria can't keep up with it. Depends on the species of crabs, but if you added a couple of crabs that produce a lot of waste, that could be the reason your ammonia is so high, which could then tie into the reason your water is cloudy.
 
jazreef said:
I did a massive water change on Friday. I took at least 20gallons out.
Click to expand...
Still with the ammonia levels it is still risky not to do one. Do you know what your ammonia levels were before the water change on Friday?
 
Nutramar Foods
WalkerLoves_TheOcean said:
Ok, so you should have bacteria established in your tank that should be able to keep up with the ammonia, but you may have had the bare minimum that was just able to keep up with the livestock you had before, but maybe since you added the crabs, the bacteria can't keep up with it. Depends on the species of crabs, but if you added a couple of crabs that produce a lot of waste, that could be the reason your ammonia is so high, which could then tie into the reason your water is cloudy.
Click to expand...
I got emerald crabs. I got them last week maybe mid-week. By that point the cloudiness had started but it’s now looking a little more cloudy. Right after my diatom bloom cleared the cloudiness came.
 
jazreef said:
I got emerald crabs. I got them last week maybe mid-week. By that point the cloudiness had started but it’s now looking a little more cloudy. Right after my diatom bloom cleared the cloudiness came.
Click to expand...
Sometimes with that, you just have to wait it out, but but or way to for sure clear it out 100% is to get a UV sterilizer, if you dont have one. I personally don't have one in my tank, but they do help clear out the water. You can also try a water clarified chemical, that is way cheaper and might help.
 
WalkerLoves_TheOcean said:
Still with the ammonia levels it is still risky not to do one. Do you know what your ammonia levels were before the water change on Friday?
Click to expand...
The last time I tested the water was maybe 2 weeks ago, I want to say it was 0 or very close to it. I can’t remember 100% but I don’t think it was where it’s at now. Everything in the tank seems fine, the fish look and seem healthy. Not sure if the reading is slighting off?
 
WalkerLoves_TheOcean said:
Sometimes with that, you just have to wait it out, but but or way to for sure clear it out 100% is to get a UV sterilizer, if you dont have one. I personally don't have one in my tank, but they do help clear out the water. You can also try a water clarified chemical, that is way cheaper and might help.
Click to expand...
I just added some ammonia detoxifier. I will test the ammonia again tomorrow and see if that helped at all.
 
jazreef said:
The last time I tested the water was maybe 2 weeks ago, I want to say it was 0 or very close to it. I can’t remember 100% but I don’t think it was where it’s at now. Everything in the tank seems fine, the fish look and seem healthy. Not sure if the reading is slighting off?
Click to expand...
They could possibly be off, but a water change won't hurt. If you can't do one right now, make sure to constantly be checking on your fish and other livestock, and if you see any signs that ammonia is affecting them, lower the ammonia levels asap by putting a chemical in to lower it, or do a water change. (I prefer a water change, and like to stay away from chemicals as they are not good for the fish, and are unnatural.)
 
Deltec
WalkerLoves_TheOcean said:
They could possibly be off, but a water change won't hurt. If you can't do one right now, make sure to constantly be checking on your fish and other livestock, and if you see any signs that ammonia is affecting them, lower the ammonia levels asap by putting a chemical in to lower it, or do a water change. (I prefer a water change, and like to stay away from chemicals as they are not good for the fish, and are unnatural.)
Click to expand...
Ok thank you, I am going to see the levels tomorrow and if it’s still bad I will need to change the water again.
 
jazreef said:
I just added some ammonia detoxifier.
Click to expand...

this doesn't work if your talking about prime.
Its a bandaide of sort, doesn't remove ammonia, but makes it less harmful for about 24 hours.
Again its a bandaide.

The only real ways to remove ammonia is zeolite in the filter which can cause other issues if you leave it in too long, and doing a water change.

Also 0.2 isn't that bad for a new cycled tank.
It can take a very long time for your ammonia to bottom out to 0 even after complete cycle.

Clowns are basically Marines too, they can tough it out with a bit of ammonia, unless you got those super rare designer clowns which have names longer then one line you can say with one breathe.

What salt did you use in your water change?
How long did you mix the salt also?
 
Deltec
Naekuh said:
this doesn't work if your talking about prime.
Its a bandaide of sort, doesn't remove ammonia, but makes it less harmful for about 24 hours.
Again its a bandaide.

The only real ways to remove ammonia is zeolite in the filter which can cause other issues if you leave it in too long, and doing a water change.

Also 0.2 isn't that bad for a new cycled tank.
It can take a very long time for your ammonia to bottom out to 0 even after complete cycle.

Clowns are basically Marines too, they can tough it out with a bit of ammonia, unless you got those super rare designer clowns which have names longer then one line you can say with one breathe.

What salt did you use in your water change?
How long did you mix the salt also?
Click to expand...
I can’t remember my ammonia readings from every time but I feel like it’s never been exactly 0. The tank is still fairly new but again, it’s been doing fine thus far. I have regular clowns, one is a basic clownfish and one is a black and yellow one. Neither are designer. I used vibrant sea salt for the water and I mixed it with a power head and just stirred it for about 20mins.
 
Naekuh said:
this doesn't work if your talking about prime.
Its a bandaide of sort, doesn't remove ammonia, but makes it less harmful for about 24 hours.
Again its a bandaide.

The only real ways to remove ammonia is zeolite in the filter which can cause other issues if you leave it in too long, and doing a water change.

Also 0.2 isn't that bad for a new cycled tank.
It can take a very long time for your ammonia to bottom out to 0 even after complete cycle.

Clowns are basically Marines too, they can tough it out with a bit of ammonia, unless you got those super rare designer clowns which have names longer then one line you can say with one breathe.

What salt did you use in your water change?
Click to expand...
Naekuh said:
How long did you mix the salt also?
Click to expand...
I mean 0.2 isn't bad, but it's not something that you want. Last thing that you want is all your fish to get sick because of ammonia poisoning. It's happened to me, with low levels like that, that I thought would be fine. Not a good feeling.
 
Tidal Gardens

IF YOU HAD TO TAKE A REEFING EXAM, WOULD YOU PASS?

  • Yes!

    Votes: 32 45.7%

  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 12.9%

  • No.

    Votes: 26 37.1%

  • Other (please explain).

    Votes: 3 4.3%
See comments…

New Posts

TCK Corals
Nutramar Foods
Tidal Gardens
Chewy.com
Top Shelf Aquatics
World Wide Corals
Deltec
Dinkins Aquatic Gardens
New Posts
Back
Top