Clowns beating up my nem?

[Scorchx1245]

So I upgraded to 40, about 3 months ago and my nem in my nano split so I thought I'd put it in my 40g a bit prematurely, I plan on transferring it when it's more stable but was low on room in my nano. This my first split in 6 months on my RBTA...so after it healed up I transferred it. Well it took 6 months for my clowns to be hosted in my nano so I thought the 3 inch RBTA would be ok. Well the clowns instantly went in the RBTA... I dose small amount of 2 part as lack of coral etc. Just some candy candy and hammers for now. Will my RBTA be ok with the onslaught? Lol or should I remove clown or put a acrylic box over my nem. My 6 inch rbta is half on a big rock half to some epoxy holding a rock to my wall....or else I would have moved him.

 

[shred5]

Hard to tell. I have seen anemones loved to death before. They do not look like in the video they are being too ruff with it.
It is possible though they could.

 

[john90009]

should be fine, that is actually gentle compared to my maroon clown diving in mine.

 

[dylana407]

IMO, 3" BTA is too small to host. You can get the 6" to move from its spot by either direct or bouncing strong flow at it.

 

[shred5]

IMO, 3" BTA is too small to host. You can get the 6" to move from its spot by either direct or bouncing strong flow at it.

I agree with this..

 

[Scorchx1245]

That was my thought exactly.... just wanted to confirm. Hopefully pointing my powered head at the 6inch in my nano it'll let go.

 

[dylana407]

That was my thought exactly.... just wanted to confirm. Hopefully pointing my powered head at the 6inch in my nano it'll let go.

Hopefully it will move enough for you to pick at the foot. I use my library card to slide carefully and slowly under the foot. Once half of the foot is exposed, I can get my fingers in there and slowly pull it off completely.

 

[Scorchx1245]

Well after 5 hours hes completely wrapped around the epoxy to where I cant eveb get credit card at his photo with out damage....I'll keep trying till lights out. Then I'm going to put it to original spot. Then tomorrow shut it off see if that works lol