Cube Tank Setup

[Cstar_BC]

Looking for some help with the hardware for plumbing a sump . The tank has a corner drilled overflow .

Can someone walk me through measuring the hole (is it the inside diameter I need or the outside ? )

 

[virtual reality]

Just a hole, No bulkhead at the bottom? If you have to find a piece to go through then you need the inside dimension.

 

[Cstar_BC]

Just a hole, No bulkhead at the bottom? If you have to find a piece to go through then you need the inside dimension.

No it’s just two holes . And I’m trying to find the right bulkhead fitting and then the fitting that fits inside that .

But figured I’d start with the holes and work my way out

 

[virtual reality]

Maybe this will help:

 

[virtual reality]

If you get a 1/2 bulkhead, 1/2 pvc will fit in. 3/4 bulkhead, 3/4 pvc fit's in it. etc.

 

[Cstar_BC]

If you get a 1/2 bulkhead, 1/2 pvc will fit in. 3/4 bulkhead, 3/4 pvc fit's in it. etc.

Thanks that was my next question!