Current USA Wavemaker Hardwire Help

[kiet_kat]

I've since upgraded my current usa wavemakers to the 1100gph and have the 660gph laying around. Any idea how I can wire it to run full power through an outlet? I assume its 12v. Thanks in advance

 

[LiveWire]

Do you not have a driver for the pump and do you happen to have a schematic? I would assume you would need to get one and purchase a 120v to 12v transformer and at 12V it would run 100% but you need to know if 12 volts is in fact the power for the pump. And a schematic would be great.

 

[kiet_kat]

Do you not have a driver for the pump and do you happen to have a schematic? I would assume you would need to get one and purchase a 120v to 12v transformer and at 12V it would run 100% but you need to know if 12 volts is in fact the power for the pump. And a schematic would be great.

Current USA's manifold can only hold 3 pumps and they are all occupied. I dont have a schematic. Looks like the website says its 24v

 

[kiet_kat]

I think the pumps itself is 12v because each pump requires the included 12v power blocks

 

[jeffchapok]

The manifolds are only $11.50 on Amazon. You'll likely spend more than this trying to rig something. However, I think you may need a 2nd controller as well. I don't know if you can start them running and then disconnect the controller. I've never tried.

 

[kiet_kat]

Switching the controller back and forth sounds like it should work. Ill try and unplug the controller. Id be amazed if it works