SO I have a breakout box and some float switches coming. the plan is to add this to my own jugs for dosing CA, ALK, NOPOX, SO my question is ------once I set this up; will fusion display the DDR icon as it does for a factory ddr container? if not how do I make this happen. the alarms are what I'm after, but I would like to have the visual in my dashboard? thanks in advance.
DDR ICON ON FUSION DASHBRD QUESTION
- Thread starter ddc0715
- Start date
- Tagged users None
SuncrestReef
That Apex guy
There’s a well-known DIY hack you can do to trick the DOS into thinking you have a DDR attached so it will display the DDR tile on your dashboard. This hack involves connecting a resistor between two pins on the DOS DDR socket.
Here’s a detailed thread on the subject:
www.reef2reef.com
Here’s a detailed thread on the subject:
Apex DOS DIY level switch?
Has anyone made a DIY harness that attaches to the 6 pin connector on the DOS unit? The optical sensors used by the DDR are a simple 3 wire switch (GND, +12V, Switch Status). I assume if you know the pinout of the 6 pin connector it would be easy to add level monitoring to any container.
www.reef2reef.com
Well, we answered different things.
Once you set that up as described in your post with a breakout box, you will not get a DDR container. Breakout switch inputs are unrelated to DDR container.
You can have your float switches named, say "AlkLvl" and then when it is "open" your fluid is below the float level and that is your visual indication. You can also program an alarm using that "If AlkLvl open then on".
SuncrestReefer assumes you have an Apex DOS too, and then there is a little hack to get a DDR container to appear. You can then set volumes and subtract DOS usage from them.
