Don’t want to spend a fortune on dosing containers? Water bottles have become very popular to use as dosing containers. The biggest issue is that they can tip over easily – but fear not, for I have a fancy solution for you!
- Will support bottles up to 3″ diameter.
- Includes three 1/4″ all plastic quick connect bulkheads.
- Includes three 1/4″ tubing for inside the bottles.
- Stand is made from quality 1/4″ cast acrylic, with mounting screw holes pre-drilled and a cut out handle (except single.)
- Bottles are not included.
- Available in black and white.
- Works with small and large VOSS bottles as well!
Single: 4.125" wide x 4.25" deep x 6" tall
Double: 7.25" wide x 4.25" deep x 6" tall
Triple: 10.5" wide x 4.25" deep x 6" tall
Quad: 13.75" wide x 4.25" deep x 6"tall
Order HERE.
Step 1:
Use a 5/8″ drill bit (I’ve found the forstner bit works best) and drill holes in the center of each cap.
Step 2:
Push the bulkhead through the hole and tighten the screw on the bottom side. This could be a snug fit but you’ll get it!
Step 3:
Connect the supplied tubing and enjoy!
Last edited:
