I'm going to be brutally honest.....I think there are better options than this one for stand lighting. This being RGB LED rope, typically you can cut every 9 LEDs. In a six foot stand, I cant see more that 27 or these LED's being used....and that still would be very bright. The remaining can't be used unless you now purchase another power supply, wireless unit, and harnesses. In addition, assuming the power can be turned on and off and the lights would come back on, you would need to splice (cut into the wires and at a minimum, cut one) into the low voltage wire coming off the power supply and either directly attach one of the wires to the switch (using COM and NO), or attach additional wire to this splice that runs to the switch. And finally, unless you're also looking for mood lighting, I'm not sure why you'd want the ability to change colors inside your stand.
If all you wish to do is to have light inside your stand, here's a fixture I just put up in my wife's closet.....a battery operated, motion detection LED fixture that cost around $8. All it took was two screws and I was done. The head portion has 12 LEDs and is bendable as is the motions sensor eye. When you open your stand, your motion would cause this light to light.
And if the above doesn't float your boat, there are other options available.
If you have other uses for this long roll of LED's, I'd use them in that project. I use something like this to ring my screened in porch....has a very nice effect when sitting out there on a warm summer evening.
If you wish to proceed with the LED rope, I'm more than happy to explain in greater detail how to do it.
