DIY Reefbrite XHO - APEX interface?

[Rybren]

I'm just wondering if anyone has built their own APEX interface to work with the Reefbrite XHO lights. A Google search came up with nothing for me.

Thanks.

 

[ngvu1]

There was a post very similar to your question. Basically yes there is a way. You need a device to convert 0-10v to PWM signal for RB...


Check on this forum for links or you can google "0-10v to PWM"


Good luck and keep us posted on your results

 

[Rybren]

Thanks. I found the 0-10v to PWM converters on ebay, but I have no idea what to do with them

I guess my search skills are like my hairline - receding quickly. I have not been able to find anything on building the interface.

 

[ngvu1]

Did you search on R2R for the Reefbrite links? I posted a few comments on that too... However it will be hard to search for all my post since this **** posted too much lol

 

[ngvu1]

found it

https://www.reef2reef.com/threads/connecting-diy-leds-to-apex.272668/#post-3279535

 

[Rybren]

Yes, I saw that thread, thanks. It discusses dimming the Meanwell drivers, but I can't figure out how it would apply to the Reefbrites. The Reefbrite power supply is a 24V/4A brick that feeds into the LED strip.

The company offers a manual dimmer that simply plugs into the line between the power brick and the LED strip. I'm guessing that it is a potentiometer of sorts that varies the voltage. Their APEX interface works on a similar setup - line in from the power supply and line out to the strip; it also has a line going to the APEX.

I'm guessing that what I need is a board that can use a 0-10V input to vary the voltage. I think.

 

[ngvu1]

Well, you need to filter the information you need

The reefBrite is dimming from PWM, how rapidly the LEDs are turned on and off. The apex is controlling the 0-10V output. The device, Voltage to PWM Converter Module, is reading the 0-10V input received from the Apex and controls the PWM output to the ReefBrite.

So you need a CAT5 cable cut in half for the wire break out and and extension cord, 2 wire type is better for this, for the reefBrite power brick. and the module
http://www.ebay.com/itm/0-5V-0-10V-...81cc64&pid=100338&rk=1&rkt=30&sd=252509231378

 

[ngvu1]

I speculate the 4 holes are for the input and the 2 holes are for the output.... the apex 0-10v will go to 2 holes and the 110V ac will go to the other 2 holes on the input side. I have never looked into this module. That is the only thing I am not sure about this.....

This is very clear on what it does...just cost more LOL

https://www.amazon.com/dp/B00PQASDX0?psc=1

 

[Rybren]

Hey, that's great info! Thanks!

I think that I can handle that!

Off to do some buying...

 

[justingraham]

How much did this end up costing ya? And did it work?

 

[Rybren]

Are you familiar with the expression "life is what happens to you while you're busy making other plans?"

Let's just say that I've been experiencing a lot of life lately. Tank stuff has been put on the back burner for a bit.